5
Press “Exec” key, select “Exec 1”, the LabTec™ will show the following display:
While the message is being displayed, the LabTec™ checks the scale communications parameters
and the following display is shown:
Place the sample bag or container onto the scale and underneath the dispensing tip. Press “RUN” key
or the foot switch. The LabTec™ will show the following display:
The LabTec™ starts dispensing while the following display is shown:
DW stands for the Dispensed Weight and CW represents the delivered Cumulative Weight. When the
dispensing cycle is completed, the following displays are shown:
Remove your filled sample bag or container and initiate the second dispensing cycle.
SCALE INITIALIZATION
Please Wait
WEIGHT SET:
25:00 G
Press RUN When Ready
REMOVING TARE WEIGHT
Please Wiat
DW= 00.00 G
CW= 00.00 G
DW= 25.00 G
CW= 25.00 G
DISPENSING
Completed
WEIGHT SET:
25.00 G
Press RUN When Ready
Note: If you have more than one DISP. WEIGHT, store one DISP. WEIGHT in “Edit 1”,
e.g. “10.00G”, while a second DISP. WEIGHT is stored in “Edit 2”, e.g. “100.00G”. Up to ten
different sets of parameters can be stored in “Edit 1” through “Edit 10”.
To Next Page
Loading...
