Parker SLVD2N - 17 Appendix D: Flash Information

Parker Hannifin S.p.A S.B.C. Division SLVDN User’s Manual
Page 176 of 181
17.Appendix D: Flash information
•
TO SAVE USA IL b99.15 PARAMETERS
•
TO SAVE THE PLC USA IL b99.14 PROGRAM
•
TO CHANGE THE INSTRUCTIONS, PLC b99.13 MUST BE 0
•
WHEN THE OPERATING MODE IS CHANGED, YOU MUST USE b99.11 TO LOAD
THE DEFAULT PARAMETERS (b40.2 MUST BE 0)
•
BEOFRE CHANGING Pr31, BE SURE THAT b40.2=0
•
THE SPEED REFERENCE WILL BE LIMITED TO THE VALUE OF Pr32
•
USING THE TORQUE CONTROL, Pr2 AND Pr3 MUST BE SET TO 1000
•
TO USE THE ACTIVE OPERATING MODE, b40.2 MUST BE 1
•
IF YOU CANNOT MODIFY THE READ-WRITE PARAMETERS USING THE
KEYPAD, BE SURE THAT E b99.7 IS 0. IF IT WAS 0, PROBABLY THE SAME
PARAMETERS WERE MODIFIED BY THE PLC PROGRAM.