USB Data Link Adapter 18
Software Tools for the USB-DLA
1. The filename should start with the DLA product number 779.
Never program the DLA with firmware file that does not start with 779.
2. The filename should end with the application version number.
Never program the DLA with an application code that has a lower version
number.
3. The file type should be .VSF.
The software will display an alert asking you if you are sure you want to reprogram
the DLA. Click Yes to continue. A progress bar will move across the screen. A dialog
box will inform the user if the update was successful.
Figure 11: Updating the DLA firmware with udutool
USB update tool will only allow you to update only the application code in the DLA
and not the bootcode. This means that if you interrupt the update, you should be
able to run it again and complete the update. However, it is highly recommended
that the update be run without interruptions. The DLA should only be disconnected
when USB update tool reports the update has completed successfully.
To Next Page
Loading...
General