43
GB
Cleaning/Maintenance
Pull out the mains plug.
Danger of electric shock.
Never hose the appliance down
with water. Never use aggressive
cleaning agents or solvents. This
could damage the appliance.
If the single-use thermal fuse has
permanently disconnected the pow-
er circuit, the device must be sent to
a service centre for repair.
General Cleaning Work
Clean the equipment after each
use:
• Carry out cleaning outside in order to
avoid mess.
• Take off the container lid (
5) and
empty the metal container (
10).
Clean the metal container with water
and allow it to dry.
• After removing the suction hose (
11), clean the dust and soot particles
from the connections. This ensures that
the suction hose can be inserted again
easily.
• Clean the wire lter basket and the
pleated lter (see below).
Cleaning the Wire Filter
Basket and Pleated Filter
Replace the pleated lter if it is
worn, damaged or heavily soiled
(see “replacement parts“).
1. Take off the container cover (5).
2. Turn the wire lter basket (14)
anticlockwise and take it off.
Tap out the wire lter basket.
3. Tap out the pleated lter (13)
and clean it with a paintbrush
or hand brush.
Don‘t wash the pleated
lter in water.
4. Place the pleated lter (13) on
the rotated container lid (5) (see
small image
).
Here, the
0mm
15a15b
rubber ring
must be on
the contain-
er lid and
press the
safety stop switch (15a) down-
wards.
5. Pull the wire lter basket (14)
over the pleated lter (13) and
turn it clockwise until it stops.
The safety stop (15b) must be
pressed down.
If there is play in the wire lter bas-
ket (14), use a nger to press down
the metal lugs (16).
Cleaning the Air Filter
1. Take off the container cover (5),
wire lter basket (
14) and
pleated lter (
13).
2. Take the air lter (17) out of the
lter housing (18).
3. Clean the lter with soap and
water and allow it to dry in the
air.
4. Place the air lter (17) back in
the lter housing (18).
To Next Page
Loading...
