45
GB
Trouble shooting
Problem Possible cause Fault correction
Device does not start
Mains voltage is not present
Check plug socket, power cord,
line, plug and fuse, where ap-
propriate, repair through electri-
cal specialist
The equipment is not
switched on
Switch on the equipment (see
“switching on/off“)
Safety stop due to miss-
ing or incorrectly inserted
pleated lter (
13)
Insert the pleated lter correctly
(see “cleaning/maintenance“)
Defective on/off switch
(
6)
Repair through customer service
Defective motor
The single-use thermal fuse
has disconnected the power
circuit
Low or lack of suction
Suction hose (
11) or suc-
tion tube (
12) blocked
Remove obstructions and block-
ages
The metal container (
10)
is not closed
Close the metal container
The metal container (
10)
is full
Empty the metal container (see
“cleaning/maintenance“)
The pleated lter (
13) is
clogged
Clean or replace the pleated
lter (see “cleaning/mainte-
nance“)
The air lter (
17) is
clogged
Clean the air lter (see “clean-
ing/maintenance“)
To Next Page
Loading...
