PARMA-TECHNIK MIKRON III A User Manual

,~
MIKRON III A
OPERATING INSTRUCTIONS
11
5.3. Warm-up and Increasing Power Setting
Maintain approximately 1 000 rpm
for two minutes, then switch battery
charging ON and insrease engine
speed to approximately 1 500 rpm for
2 to 5, minutes, according to
ambient air temperature, t I an oil
temperature of 40 deg. C and a
cylinder head temperature of 120 deg. C
reached. Control by means
cooling flap setting, if required.
Performance Check
Move throttle lever slowly to its take-off power position (continuously
within 2 sec.). The engine must reach the maximum ground speed. Check,
by comparing the engine speed with Flight Manual data.
Check engine acceleration and deceleration moving the throuttle
gradually from idle'to take-off power setting within 2 seconds and back
to idle at identical rate.
Ignition Maaneto Check
Carry out ignition magnetos check by switching. By ~aximum throttle
the prescribed engine speed dro~ at switching - off each magneto
shoved be 30 50 rpm coincidentaly.
Battery Charging Check
Electrical system vOltage should not exceed, at an engine speed
corresponding to take-off power setting, the following values:
14,1 V at an ambient air temperature of 20 deg. C
1417 V at an ambient air temperature of 0 deg C
IS,S V at an ambient a temperature -20 deg. C
Engine cooling is carried out at increased idle power setting of
1 200 rpm.
5.4. Take-off
Set throttle to take off power se~ting
Do not exceed approved limits of cyl'inder head and oil, temperatures
and of oil pressure.
Maintain recommended temperatures by means of cooling flap cont'rol.
Issued 9/95

PARMA-TECHNIK MIKRON III A Specifications

General

Brand	PARMA-TECHNIK
Model	MIKRON III A
Category	Engine
Language	English