Parrot ZIKMU SOLO User Guide

6 Getting started
Remote control
Insert the provided remote control battery into the specific battery compartment.
Note: Use only a CR2032 battery.
Note: Dispose of used batteries in compliance with current recycling legislation in the country of use.
To pair the remote control to the Parrot Zikmu Solo :
1.
Reboot the speaker.
2.
Wait for the light to stop flashing.
3.
Press the SOURCE and buttons simultaneously to pair the remote control
to the speaker. You have one minute after rebooting the speaker to perform
this action.
> The , and lights flash simultaneously to indicate that the pairing
was successful.
Note: The pairing of the remote control is necessary after a reset of the speaker (long press on the Reset button).
Turning the Parrot Zikmu Solo on / off
Press the button of the remote control or control panel to turn the speaker on / off.

Parrot ZIKMU SOLO Specifications

General

Impedance	- Ω
Speaker type	-
Frequency range	- Hz
RMS rated power	100 W
Audio output channels	1.0 channels
Tweeter	Yes
Product color	White
Volume control	Digital
Equalizer	No
Apple docking compatibility	iPhone 3GS, iPhone 4, iPhone 4S, iPod Nano 2, iPod Nano 3, iPod Nano 4, iPod Nano 5, iPod Nano 6, iPod Touch 4, iPod Touch 5
Amplifier class	D
Compatible products	iPod, iPhone
Power source type	AC
Power consumption (typical)	115 W
Cables included	AC, Audio (3.5mm)

Weight and Dimensions

Weight	6200 g