EasyManua.ls Logo

Parsun F30 BM - Engine Stopping and Trim Tab Adjustment

Parsun F30 BM
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
25
WARNING
Do not over-tighten the friction adjuster. If there is too much resistance, it could be difficult to
move throttle lever or grip, which could result in an accident.
2.9 Trim tab
The trim tab should be adjusted so that the steering control can turned to either the right or left by
applying same amount of force.
WARNING
An improperly adjusted trim tab could cause difficult steering. Always test run after the trim
tab has been installed or replaced to be sure steering is correct.
Be sure you have tightened the bolt.
If the boat tends to veer the left, turn the trim tab to the port side. If the boat tends to veer the right, turn
the trim tab to the starboard side.
2.10 Stopping engine
NOTE:
Before stopping the engine, first let it cool off for a few minutes at idle or low speed. Stopping
the engine immediately after operating at high speed is not recommended.

Related product manuals