3. Secure the clamp bracket to the transom using the appropriate bolts. For details, consult your
PARSUN dealer.
WARNING:
Avoid using bolts, nuts or washers inappropriate. After tightening, test run the engine and
check their tightness.
2.2 Breaking in engine
Your new engine requires a period of breaking to allow mating surfaces of moving parts to wear
in evenly.
CAUTION:
Failure to follow the break-in procedure could result in reduced engine life or even severe engine
damage.
1．For the first hour of operation:
Run the engine at 2000r/min or at approximately half throttle.
2．For the second hour of operation:
Run the engine at 3000r/min or at approximately three-quarter throttle.
3．For the next eight hours of operation:
Avoid continuous operation at full throttle for more than five minutes at a time.
4. Operate the engine normally.
9
https://www.boat-manuals.com/
To Next Page
Loading...
