6. Pull the rope slowly until resistance is felt.
7. Give a strong pull straight out to crank and start the engine. Repeat it necessary.
5.3 Treatment of submerged motor
If the outboard is submerged, immediately take it to a PARSUN dealer. Otherwise some corrosion
may begin almost immediately.
1. Thoroughly wash away contaminants with fresh water.
2. Remove the spark plug(s), then face the spark plug hole downward to allow any mud, or
contaminants to drain.
3. Drain the fuel from the carburetor, fuel filter, and fuel line. Drain the engine oil completely.
4. Fill the sump with fresh engine oil.
5. Feed engine fogging oil or engine oil through the carburetor(s) and spark plug holes while
starting the engine.
45
https://www.boat-manuals.com/
To Next Page
Loading...
Need help?
General
