7. Insert and tighten the gear oil drain screw (If necessary, change the seal spacer).
3.10 Cleaning fuel tank
WARNING:
Keep away from sparks, cigarettes, flames, or other sources of ignition when cleaning
the fuel tank.
Cleaning the fuel tank in a well-ventilated open air.
1. Empty the fuel tank into an approved container.
2. Pour a small amount of suitable solvent into the tank. Install the cap and shake the tank. Drain
the solvent completely.
3. Pull the fuel joint assembly out of the tank.
4. Clean the filter in a suitable cleaning solvent and allow it to dry.
5. Replace the gasket with a new one. Reinstall the fuel joint assembly and tighten the screws
firmly.
3.11 Checking and replacing anode(s)
Inspect the external anodes periodically. Remove scales from the surfaces of the anodes. Consult
a PARSUN dealer for replacement of external anodes.
CAUTION:
Do not paint anodes, as this would render them
ineffective and can cause more rapid engine corrosion.
35
https://www.boat-manuals.com/
To Next Page
Loading...
Need help?
General
