WARNING:
Stop the engine before adjusting the trim angle.
Use care to avoid being pinched when removing or installing the rod.
Use caution when trying a trim position for the first time. Increase speed gradually and
watch for any signs of instability or control problems. Improper trim angle can cause
loss of control.
2.11Tilting up and down
If the engine will be stopped for some time or if the boat is moored in shallows, the outboard motor
should be tilted up to protect the propeller and casing from damaged by collision with obstructions,
and also to reduce corrosion.
WARNING:
Be sure all people are clear of the outboard motor when tilting up and down, also be careful
Not to pinch any body parts between the drive unit and engine bracket.
NOTE:
Do not tilt up the engine by pushing the tiller handle because this could break the
handle.
The outboard motor cannot be tilted when in reverse.
2.11.1 Tilting up
1. Place the gear shift lever in neutral.
23
https://www.boat-manuals.com/
To Next Page
Loading...
Need help?
General
