4. Remove the oil level plug to allow the oil to drain completely.
CAUTION:
Inspect the used oil after it has been drained. If the oil is milky, water is getting into the gear
case which can cause gear damage. Consult PARSUN dealer.
5. Use a flexible or pressurized filling device, and inject the gear oil into the gear oil drain screw hole.
6. When the oil begins to flow out of the oil level plug hole, insert and tighten the oil level plug (If
necessary, change the seal spacer).
7. Insert and tighten the gear oil drain screw (If necessary, change the seal spacer).
3.9 Cleaning fuel tank
WARNING:
Keep away from sparks, cigarettes, flames, or other sources of ignition when cleaning the fuel
tank.
Cleaning the fuel tank in a well-ventilated open air.
１. Empty the fuel tank into an approved container.
２. Pour a small amount of suitable solvent into the tank. Install the cap and shake the tank. Drain the
solvent completely.
44
To Next Page
Loading...
Need help?
General
