6. Pull the rope slowly until resistance is felt.
7. Give a strong pull straight out to crank and start the engine. Repeat it necessary.
5.3 Treatment of submerged motor
If the outboard is submerged, immediately take it to a PARSUN dealer.Otherwise some corrosion may
begin almost immediately.
1. Thoroughly wash away contaminants with fresh water.
2. Remove the spark plug(s), then face the spark plug hole downward to allow any mud, or
contaminants to drain.
3. Fill the sump with fresh engine oil.
4. Feed engine fogging oil or engine oil
through the carburetor(s) and spark
plug holes while starting the engine.
55
To Next Page
Loading...
