5. Fill the tank with fresh water to above the level of the anti-cavitation plate.
CAUTION:
If the fresh water level is below the level of the anti-cavitation plate, or if the water supply is
insufficient, engine seizure may occur.
6. Start the engine. Flush the cooling system. Perform the flushing and fogging at the same time, as
fogging/lubricating of the engine is mandatory to prevent engine rust.
WARNING:
Do not touch or remove electrical parts when starting or during the operation.
Keep hands, hair, and clothes away from the flywheel and other rotating parts while the engine
is running.
7. Run the engine at a fast idle for a few minutes in neutral position.
8. Just prior to turning off the engine, quickly spray “Fogging Oil” alternately into each carburetor or the
fogging hole of the silencer cover, if equipped.
9. If “Fogging Oil” is not available, run the engine at a fast idle until the fuel system empties and the
engine stops.
10. If “Fogging Oil” is not available, remove the spark plug(s). Pour a teaspoonful of clean engine oil into
each cylinder. Crank several times manually. Replace the spark plug(s).
51
To Next Page
Loading...
Need help?
General
