6
S80/c and S800 terminals use standard 57mm (w) x 50mm (dia) thermal paper rolls.
Replacing printer paper:
1. Engage printer cover release ap to open printer bay.
2. Remove existing roll core and place new roll in printer well (when replacing a paper roll, the tongue of paper
should be feeding up and over; out towards the top of the terminal).
3. Pull out tongue of paper so it is coming out of feeder and close the printer cover.
To order paper rolls or other accessories please contact Smartpay on 0800 476 278 or visit our website smartpay.co.nz
Please read the Getting Started Letter that is provided with your Smartpay EFTPOS equipment. Our technical
helpdesk team (THD) can be contacted if you would like any assistance and to release the security key and
perform your initial Logon.
1. Place the S80 or S800 base unit face down on the counter.
2. Plug the barrel end connector of the power adapter cord, into the “POWER” socket.
3. Plug the appropriate communication cords into their communication sockets:
- For Broadband/Fibre Internet plug the Ethernet cable into the “LAN” socket.
- For Dial-up, plug the phone cable into the “LINE” socket.
4. Plug the S300 cord into the “PINPAD” socket.
5. Tuck cables into the recessed cable tidy guides as required.
6. Turn all hardware right side up.
7. Plug into mains power and switch on by pressing and holding the power button on base unit.
8. Terminal will perform boot up sequence.
9. Contact Smartpay THD to release security key and perform initial Logon.
For a more consistent contactless card experience the swipe/insert quick start option has been removed. To
follow best security practices for payment card handling the customer should always present their own card
(swipe/insert/tap) to the terminal wherever possible.
PAPER ROLLS
SETTING UP YOUR EFTPOS EQUIPMENT
CONTACTLESS TRANSACTIONS
ELECTRONIC OFFLINE VOUCHERS
TRANSACTIONS OVERVIEW
To Next Page
Loading...
Need help?
General
