NMS044 Reference Manual Shipping and Storage Requirements A-6
A.2.2 Preparing the System for Long Term Storage
If you plan to store the system for more than one week, unplug and remove the battery
from the case.
A.2.3 Removing Cables From the Case
If the cables need to be removed from the case, follow these steps.
Step 1. Remove the CBL228-03 from the charge controller by unscrewing the terminals
and gently pulling the cable out. Remove the CBL222-08 from the top of the
831C by pressing the release button and pulling out.
Step 2. Unscrew the gasket by turning counterclockwise.
Step 3. Using your hands on either side of the case wall, gently push the rubber stopper
out. The cable can be removed through the slit in the stopper.
Step 4. If needed, follow the steps in reverse order to reinstall the cables in the case.
To Next Page
Loading...
Need help?
General