Page 16
Fittings Kit Contents
Supplied in the Fittings Kit are all the fittings required to connect the generator to the
application. The contents of the Fittings Kit are as follows:
1. 6mm Teflon Tubing x 3m
2. 1/4” Teflon Tubing x 3m
3. 6mm PE Tubing x 3m
4. 1/4” Compression Fitting x 1
5. 6mm Push-Fit Fitting
x 2
6. Flow Control Silencer x 1
7. 8mm Hex Key x 1
8. UK Mains Power Cable* x 1
9. EU Mains Power Cable* x 1
10. US Mains Power Cable 110v ** x 1
11. US Mains Power Cable 230v* x 1
All of the generators output ports are located on the output panel at the rear of the
unit.
* Genius 1022, 1023 and NM32LA Only
** NM32LA 110V Only
To Next Page
Loading...
