Page 29
Cleaning
For cleaning instructions specific to the i-Flow and Refrigerant dryer, please refer to
the respective User Manuals provided with this system. Clean the outside of the system
only using warm soapy water and a clean damp cloth. Ensure the cloth is thoroughly
rung out to remove excess fluid prior to use. Do not use decontamination or cleaning
agents that could cause a HAZARD as a result of a reaction with parts of the Generator
or material contained within it. If there is any doubt about the compatibility of decon-
tamination or cleaning agents, please contact your Peak Gas Generation representative.
Cleaning should only be undertaken with the power switched o and
the power cord removed from the rear of the generator.
Under no circumstances should any solvents or abrasive cleaning
solutions be used as these can contain fumes that could be harmful to
the generator.
Care should be taken with Leak Detections Liquids.
To Next Page
Loading...