Page 5
Technical Description
Basic Concept
The i-Flow N2 Select is an all-in-one Nitrogen gas generation solution. It consists of an
air dryer, filtration, carbon tower, nitrogen generator & process tank, all conveniently
assembled on a plug & play skid plate. The system requires an inlet feed of compressed
air supply to operate, which is passed through a refrigerant dryer & carbon tower, with
pre-& post filtration at multiple stages before entering the i-Flow nitrogen generator.
The generated nitrogen is then fed to a process tank, before returning back through
the generator for a final quality/purity check, before passing downstream to the
application. Should the demand for nitrogen be less than the rated output flow, or
indeed should the demand stop, the generator will go into ‘Standby’ mode. At this point
the gas generation system will stop producing nitrogen. Once demand resumes & the
process tank pressure goes below a certain level, the generation system will resume
normal operation and begin to produce nitrogen gas again.
To Next Page
Loading...