Peavey CS 800X - Connection Diagrams; Bridge Mode Connection

BRIDGE MODE
BRIDGE
POSITION
NOTE:
WHEN TRANSFORMER BALANCED
INPUT IS NOT NECESSARY, HIGH Z
INPUTS MAY BE USED
DDT^” Compression ,
Should be Enabled for'
System Protection
Mode Switch Must be/
in "Bridge" Position
iM
TIUNSrODMCR (P
-cxrrpuTS -
4001W/4 OHMS 4aV M
NOTE:
FOR TRANSFORMER
_ BALANCED INPUT,
INSTALL PL"“ 2 AND
PUSH SWITCH TO "IN"
POSITION
SYSTEM LOAD
(NOTE: 4 ohms minimum)
X indicates not used.
FULL RANGE MONO
NOTE:
WHEN TRANSFORMER BALANCED
NPUT IS NOT NECESSARY, HIGH Z
INPUTS MAY BE USED
DDT ™ Compression
Should be Enabled tor >
System Protection
Mode Switch Must be in/
"Stereo” Position
PATCH CABLE
(SINGLE CONDUCTOR SHIELDED)
-. 9 :
NOTE:
FOR TRANSFORMER
— BALANCED INPUT,
INSTALL PL ™ 2 AND
PUSH SWITCH TO "IN¬
POSITION
TO SPEAKERSi I TO SPEAKERS
FULL RANGE STEREO
NOTE:
WHEN TRANSFORMER BALANCED
INPUT IS NOT NECESSARY, HIGH Z
INPUTS MAY BE USED
DDT^" Compression
Should be Enabled for
System Protection
Mode Switch Must be in
"Stereo" Position
LEFT OUTPUT
FROM MIXER
NOTE:
FOR TRANSFORMER
— BALANCED INPUT,
INSTALL PL ™ 2 AND
PUSH SWITCH TO "IN"
POSITION
'TO LEFT SPEAKER