Peavey DPM C8 - Polarity Assignment.26; Program Chain Up;Down Footswitches.26

Other control sources can be used instead of footpeclals. You can feed in a 0 to +10V control signal (as
generated by analog synthesizers) or use any 10k potentiometer, hooked up as shown below.
2.16a Parameter Assignment
Footswitches: Off, MIDI controllers 1 - 120, program changes 0 -127, sequencer start/stop toggle, Range
Mute Status Goggle), Range Mute Status (Hold).
CV Pedals: Off', MIDI controllers 1 -120, channel pressure, pitch bend (full range), pitch bend (up only),
pitch bend (down only).
When a footswitch is programmed to Range Mute Status, depressing the footswitch will change the mute
status of any range that has that footswitch enabled (see section 2.11). In Toggle mode, a second press of
the footswitch will return the ranges to their previous status. In Hold mode, releasing the footswitch will return
the ranges to their previous status. This feature allows selective range layering/switching without your hands
leaving the keyboard.
Place the cursor over the parameter to be assigned and select the desired assignment.
2.16b Polarity Assignment
Polarity can be programmed for the CV pedals, but not for the footswitches. Press the Polarity soft button
while the cursor is on the CV pedal to be edited.
2.16c Program Chain Up/Down Footswitches
There are also two program chain up/down footswitches available, but these are not programmable. For more
information, see section 2.0.
2.166 Save Preset
Press the SAVE soft button and refer to section 2D.