Peavey DPM C8 - Chapter 4 Global Operations; SECTION 4 A GLOBAL, PAGE 1

Chapter 4 Global Operations
SECTION 4A GL OBAL, PA GE 1
This screen contains five global functions and allows access to the other global screens.
GLOBAL
Pr-9/Uol/Bank Edit Transmit: OFF
Xnit ALL OFF Preset Ch9: OFF
Data Entry Slider : Leftl
Ftsu Preset Chain Select : OFF
External Controller Type : *DESRBLE*
4.0 Prg/Vo I/Bank Edit Transmit
If this is turned ON, MIDI messages will be sent while editing values on the Vol/Prg screen (section 2.10). If
this is turned OFF the bank, program changes and volume messages won’t be sent until you switch presets.
Normally, this parameter is set to ON. This allows you to search for the desired presets on your MIDI gear
by editing the Vol/Prg screen and listening as you go.
4.1 X mit All Off with Preset Change
To eliminate the chance of stuck notes, changing a preset can generate an All Notes Off command.
Place the cursor on the Xmit All Off with Preset Change parameter and choose between ON (All Notes Off
is generated on preset selection) and OFF ( the All Notes Off command is not sent on preset selection).
4.2 D ata Entry Slider
Although the C8 defaults to Slider 1 serving as the data slider, any slider can serve this function. You may
also choose None if you prefer to have all four sliders perform their programmed function at all times.
Place the cursor on the Data Entry Slider parameter and .select the desired slider for data entry'.
4.3 F ootswitch Preset Chain Select
The C8 allows for two chains of programs, with increment and decrement footswitches that step up or down
through the programs, respectively. This parameter determines which chain will be affected by the
footswitches. (The Inc and Dec buttons also step up and down the chain.)
Place the cursor on the Footswitch Preset Chain Select parameter and choose between OFF, Chain 1 and
Chain 2. Then refer to Section 4C.