Peavey DPM C8 - SECTION 2 D PRESET, SAVE PRESET SCREEN

SECTION 2D PRESET SAVE PRESET SCREEN
A preset can be saved from the following pages:
Ranges
*•- Vol/Prog
Enables
•** Velocity
Sequence (accessed from the Sequence function button)
«- Wheel
Button
Slider
Foot
Upon pressing the page’s SAVE soft button, the following screen appears:
The top line shows the current preset number and name (if the preset has been edited, the number will be
replaced by **).
2.17 Selecting the Destination Preset Number
The next lower line shows die destination preset to which the current preset will be saved. Hie cursor will lx: on
the destination preset number. Again, use your preferred input method to select die desired destination preset.
2.18 Naming the Destination Preset
Use the left/right buttons to move the cursor over the character to be changed and enter the new character
using either normal methods or the keyboard itself. Characters appear in the following order (starting from
the bottom of the keyboard or data slider, which gives a blank character):
Upper case letters A-Z, lower case letters a-z, numbers 0-9. + - = () , i, & a % $ # @ ! ~ < U I 1 I : :; ? /
2.19 Canceling and Sa i ring
To cancel the save operation, press the Exit button. To save, press the Enter button.
2.20 Accessing Other Pages
Note that you can also access the Ranges page (section 2B), Control Assignment page (section 2C). and
Volume/Program Change Settings page (section 2.10) from the Save Preset page by pressing the appropriate
soft buuon.