Peavey DPM C8 - Delete; Format.40; Naming Files and Adding Comments.40

To load all presets, global data, all data (presets and global data), or the sysex bulk buffer from disk:
1. Choose Disk as the .source and choose the desired destination (All Presets, Global Data, All Data or
Sysx Bufr).
2. Press the LOAD soft button.
Note: Any data that was saved to MIDI can be loaded back into the C8 by sending that data to the C8’.s MIDI
input #1 from a librarian or sequencer. The C8 will accept the data automatically (you don’t need to
press any buttons or be on a particular screen).
5.7 DELETE
This function deletes a file from disk.
1. Press Select; a directory of disk files appears.
2. Place the cursor over the file to be deleted.
3. Press Delete.
4. A warning screen appears that shows the file name to be deleted.
3. P ress Exit to back out, or Delete to erase the file.
5.8 FORMAT
This function formats a blank disk, or reformats a previously formatted disk.
Caution! Formatting a disk erases any files that exist on that disk.
To format:
1. Press Select; a screen prompts you to insert the disk to be formatted.
2. To back out. press Exit. Otherwise, press the Enter function button.
3. A screen appears to advise you of the format status.
4. When formatting is complete, the screen informs you whether any bad sectors were found. Bad sectors
are blocked out so they are not available for storage, thus decreasing the amount of available storage
space. If a disk shows significant number of bad sectors, discard the disk and format a new one.
5.9 NAMING FILES AND ADDING COMMENTS
AH Presets, Global Data, All Data, and SysEx Buffer files can be named prior to saving to disk. During the
saving process, a screen similar to the following appears: