June 11, 2012 Version 1.6.4b.1 65
No link or CM-1 missing or malfunctioning, and NioNode is configured
to use CM-1.
No link or CM-1 missing or malfunctioning, and NioNode is not
configured to use CM-1.
Note: Even if the NioNode has not been configured to use its CM-1 (in the project design),
link and Conductor status are still reported and the unit will be visible as a CobraNet node on
the network it is attached to. You will only see RED, however, if the NioNode has been
configured to use its CM-1 and there is a problem with link or with the CM-1 module.
Mass storage (CompactFlash) read or write activity.
Tip: The IDE LED indicator is remarkably similar to the disk status LED you may have on the
front of your PC or on the bezel of your laptop.
Indicates there is an error or warning condition of interest.
No status change of interest.
Tip: This indicator is paired with a button. When the LED blinks, the button can be pressed to
cause the LCD to navigate to a page displaying the source of the condition.
Unit is booting up or down.
To Next Page
Loading...
