Chapter 1 - About this guide
4 Version 1.6.4b.1 June 11, 2012
configuration of associated software.
Physical installation of an nTouch 180 and configuration
of associated software.
nTouch 180 Hardware Manual
Physical installation of an nTouch 60 and configuration
of associated software.
nTouch 60 Hardware Manual
Physical installation and initial configuration of an
xControl LCD.
xControl LCD Hardware Manual
Understanding how CobraNet works.
Physical installation of an nWall device and connection
to the network.
Software, firmware and manual versions
The information in this manual is based on a specific software version (for PC software, like
NWare) or firmware version (for hardware devices, like NION). The version of the manual,
shown on the front page, includes the software or firmware version and the revision number of
the manual itself.
Manual version 1.6.1f.0 (example)
Software or firmware version.
Manual revision number. Revision 0 is the first
version to be published for a release. Revision
1,2 etc. indicate that the manual is a
replacement for the previous version published
for this release.
Note: To reduce the risk of compatibility problems, we recommend that all the hardware
devices (NioNodes, nControl nodes etc.) on the network run the same firmware version, and
that the version matches the version of NWare you are running.
Sending feedback
We are always looking for better ways to provide information about our products, and your
input is always appreciated. If you have a comment about this manual or would like to make a
suggestion, please write to:
To Next Page
Loading...
Need help?
General
