- 27 -
Installing your child restraint in the vehicle
PROPER LEVELLING OF CHILD
RESTRAINT IN REAR FACING MODE
When properly installed according to the
following sections, the child restraint used
in rear facing mode should have a backrest
angle of 35° - 45° from vertical. If it is not
possible to reach such angle, use a pool noodle
or a rolled towel to further recline the seat.
Use the line drawn on the product as a
reference. When the line is horizontal, the
backrest angle will be at 45° with vertical.
NOTE: make sure that the angle
does not exceed 45° with vertical.
Important! Newborn infants should be
properly reclined. If the seat reclines too
much, your infant can be ejected from the
seat in an accident. If too upright, it can cause
breathing problems.
To Next Page
Loading...
