- 28 -
Installing your child restraint in the vehicle - Rear Facing mode
REAR FACING MODE USING
LATCH SYSTEM
1. Recline the child restraint to the rearfacing
position as shown in the picture. To recline
the child restraint, pull the handle located
below the front edge of the shell (A)as shown
in detail. An audible "click" is heard when
the seat is properly locked into position.
Note: for easier adjustment, lift the back of the
seat slightly with your free hand to remove
some weight from the mechanism.
2. Disconnect the latch straps from the
storage bar by pushing on the red button
and pulling the straps at the same time.
3.
Slide the straps toward the front of the child
restraint. Check that the straps are not reversed.
4. Lean the reclined seat, unoccupied, on
the selected vehicle seat in the rearfacing
mode making sure that the front part of
the seat touches the vehicle seat backrest.
1
A
A
B
2
To Next Page
Loading...
