- 33 -
13 mm
1/2 inch
6. The picture shows the correct belt path
when the child restraint is attachd to the
vehicle using a lap/shoulder belt.
Make sure the child restraint is properly
leveled as explained on page 27.
Verify that the child restraint is secure. A
secure child restraint will not move more than
1 inch near the seat belt anchors.
Use of a locking clip
If the lap/shoulder belt in your vehicle
requires a locking clip according to page 19,
Primo Viaggio Convertible is provided with
one in the tether compartment (page 12).
To install the locking clip, hold the shoulder
strap and lap belt together just above the
buckle. Unbuckle the belt while holding the
straps. Hook the locking clip around both
straps as shown.
Leave 1/2 inch space between the clip and
latch. Re-buckle the belt.
Installing your child restraint in the vehicle - Rear Facing mode
6
To Next Page
Loading...
