- 44 -
Installing your child restraint in the vehicle - Forward Facing mode
Important! Remove newborn ller cushion in
forward facing mode (see page 55).
FORWARD FACING MODE USING
LAP BELT (TYPE I)
1. Before installing the child restraint in the
vehicle, make sure that the backrest is in the
upright position or adjust it using the handle
located below the front edge of the shell (A)
as shown in detail.
2. Lean the upright child restraint, unoccupied,
on the selected vehicle seat. Make sure that
the LATCH straps are stored in their proper
location (page 39 - picture2) and that the rear
openings in the structure are free and ready
for use. Open the lock-o clips, as shown in
the picture .
3. Pull the vehicle belt at full available length
and thread the belt through the openings
in the structure behind the child restraint as
shown in the picture.
4. Buckle the vehicle belt and check that the
vehicle belt is free of any entanglement.
4
2
3
A
A
B
1
To Next Page
Loading...
