13
I USING THE LATCH
SYSTEM. If your car
has “lower universal
anchorage systems
(UAS)”, you can install the
infant car seat using the
LATCH system instructions on page
14. The anchor is a bar located where
the seat back meets the seat bottom
(slide your hand down between the
seat back and seat bottom to locate
this bar).
Important! Also read your vehicle
manual for locating lower anchors
UAS and instructions on using the
LATCH system.
II USING THE STANDARD LAP BELT/
SHOULDER STRAP. If your car does
not have universal lower anchors
UAS, install the infant car seat using
the instructions for lap/shoulder belt
straps on page 17.
When using Primo Viaggio Sip with its base, first you install the base, and
then you install the car seat on the base.
Important! Read your vehicle manual for instructions on where to best install an
Infant car seat in your vehicle.
There are two ways to install the base:
Installing the Base
To Next Page
Loading...
