25
Installing the Car Seat without the Base
Important! The base is designed to
avoid consumer misuse by reducing
the number of times the seat must be
anchored to your vehicle. Please, use
and install Primo Viaggio Sip without the
base only if needed.
Park the vehicle on level ground.
1• Adjust the restraint on the seat.
Check the red line to see that the
base is level with the ground. Thread
the lap belt through the slots on the
seat and lock the latch plate into the
buckle as shown.
2• Pull the strap to tighten the seat
belt. Press down on the seat with
your body weight and pull the strap
tighter. Once the seat is tight, check
that the red line on the side of the
car seat is level with the ground.
To Next Page
Loading...
Need help?
General
