18
3• Thread the lap belt through the slots
on the base and lock the latch plate
into the buckle as shown.
4• Pull the strap to tighten the seat
belt. Press down on the base with
your body weight and pull the strap
tighter. Then push and pull on the
base. If you can move the base more
than 2,5 cm (1 inch), tighten the belt
further. Once the base is tight, check
the level indicator. If the pointer has
moved outside of the green area,
turn the knob until the pointer is
back within the green area. You may
need to loosen the strap slightly to
do this.
Warning! If you cannot get the belt
tight enough, refer to your vehicle
manual for instructions on how to
secure the base using the type of seat
belt in your vehicle. Your baby is not
safe riding in a loose car seat.
To Next Page
Loading...
Need help?
General
