pellenc 150 - Page 12

PELLENC POWER TOOLS BATTERY 150
56_158889-A
2. Place the charger and battery in a dry, ventilated and
dust-free room at 10#25°C. Place the battery lying
in a horizontal position.
3. Connect the charger power connector (1) to the
power outlet. The charger indicator (2) lights up red.
4. Align the arrows on the charging cord connector (3)
with the charging connector (4) on the battery.
5. Connect the charging cable (3) to the charging con-
nector (4) of the battery. The charger indicator (2)
lights up green, and the battery indicator (5) flashes
orange.
6. When the gauge display (6) flashes, the battery is
charging. The charge is finished when the message
appears on the gauge display.
Once the battery is charged, first disconnect the
charging cord (3) from the battery and then the
mains plug from the charger (1).
Note
After a long storage period (new battery, winter storage etc.), when you disconnect the charger, the charge
level indicator may display a value of less than 99%. This is a normal phenomenon which can reoccur for up
to 5 charge cycles with normal use between each charge.
12