PELLENC POWER TOOLS BATTERY 150
56_158889-A
7. INCIDENTS AND TROUBLESHOOTING
7.1. RECAP OF BATTERY DISPLAY MESSAGES AND AUDIBLE SIGNALS
Normal messages
Use
fixed
Battery charge level (0 to 99)
with 1 beep per minute
Battery empty, recharge immediately
flashing with 1 beep every 10 seconds
Stop using, recharge immediately.
Only on ALPHA batteries connected to an ALPHA
Tool.
Flashing
Display off to avoid duplication with tool display
Charging
flashing every 4 seconds
Battery charge level (0 to 99)
fixed
Charging complete
Storage
Off Standby
Degraded mode messages
Use
and alternately
Stop the tool; the battery temperature is too high
and and alternately
Stop the tool; the battery temperature is too low
Electronic board out of order
Electronic board not configured
fixed
Cell voltage too low
Long beep and 1 short beep Tool stop: tool intensity too high
Long beep and 2 short beeps Incompatible tool detected
Long beep and 4 short beeps Stop the tool; the tool temperature is too high
Charging
and alternately
Charge interrupted: Battery temperature too low
and alternately
Charge interrupted: Battery temperature too high
Fault messages
Use
and 1 beep every 2 minutes for 24 hours
Voltage too low after 3 hours of non-use. Recharge bat-
tery immediately
Electronic board out of order
Short circuit on the tool connector
Long beep and 5 short beeps Loss of connection, tool not detected
18
To Next Page
Loading...