PELLENC POWER TOOLS BATTERY 150
56_158889-A
6. MAINTENANCE
6.1. MAINTENANCE TABLE
Maintenance task
At each
start-up
Every 4 hours Every week
After
each use
Every year or
as necessary
Visual inspection of the general con-
dition of the battery (no deformation
or wear)
X
Visual inspection of the general con-
dition of the charger (no deformation
or wear)
X
Check of the tightness of the tool
power cord knob
X
Check the battery level. X
Cleaning the battery, see Sec-
tion 6.2, “Cleaning the battery”.
X
Cleaning the battery, see Sec-
tion 6.3, “Cleaning the charger”.
X
Battery check by an authorised deal-
er PELLENC.
X
Important
Have the battery serviced every 400 hours or at least once a year by an authorised dealer PELLENC. Always
store the charged and clean battery in a dry place.
6.2. CLEANING THE BATTERY
1. Make sure that the battery is switched off, see Sec-
tion 4.1, “Switching the battery on and off”.
2. Ensure that the battery is disconnected from the
charger and the tool.
3. Clean the battery casing with a soft damp cloth.
Important
Cleaning shall be carried out with water only and
without detergent, chlorine or sterilising solutions
with an alkaline reaction.
6.3. CLEANING THE CHARGER
1. Ensure that the charger is unplugged and disconnected from the battery.
2. Clean the charger housing with a soft damp cloth.
16
To Next Page
Loading...