pellenc 150 - Troubleshooting

PELLENC POWER TOOLS BATTERY 150
56_158889-A
Fault messages
Charging
and alternating and continuous beep
Battery problem
and alternately
Charger problem
7.2. TROUBLESHOOTING
Symptoms
Battery dis-
play messages
and beeps
Probable cause Checks Solutions Repairer
with 1
beep per minute
Empty battery
Check that the bat-
tery is not com-
pletely discharged
Recharge the battery User
Configuring the
electronic boardThe battery
does not start
Electronic cir-
cuit board
At an authorised PEL-
LENC distributor
Change the electron-
ic board if the diodes
remain off after start-
ing and checking
the previous points
Authorised PEL-
LENC distributor
Long beep and
4 short beeps
The tool has
reached its tem-
perature limit
4 beeps from the battery
Let the tool cool down
for roughly 5 minutes
and
alternately
Battery temper-
ature too high
Let the battery
cool down for
about 5 minutes
The tool stops
during use
and and
alternately
Battery tem-
perature
Battery temper-
ature too low
Use the battery within
the correct temperature
range, see Section 2.2,
“Safety measures asso-
ciated with battery use ”
User
and
alternately
Battery temper-
ature too low
Use the battery
within the correct
temperature range
The battery
does not charge
and
alternately
Battery tem-
perature
Battery temper-
ature too high
Let the battery
cool down for
about 5 minutes
User
19