A
PREPARING THE MACHINE FOR USE
1 - Position the harness equipped with its battery.
2- Attach the machine to the harness and make sure it is balanced and well adjusted.
4- Connect the power cord to the machine
5. Power up the tool to select one of the following operating modes:
3- Check that the cutting tool does not touch the ground. Make sure the work area is clear and there is nobody within a 15 metre
radius. Check your safety devices.
MACHINE BALANCING
Put the harness hook on one of the 4 attachment positions
available on the tool.
Use the attachment point which gives you the best tool balance.
USAGE
Mode 1
Mode 2
To Next Page
Loading...
