Pelpro PPC90 - Maintaining Your Stove; Cleaning and Maintenance Overview

18 06/218390-017A
CODE #1: FUEL FEED ALARM
UNPLUG APPLIANCE, CLEAN FIREPOT AND MAKE SURE FIREPOT IS
INSTALLED CORRECTLY, CLEAN FIREBOX AREA, FILL HOPPER, PLUG APPLIANCE
BACK IN, PRIME FEED TUBE IF NEEDED AND TURN APPLIANCE ON.
AFTER A FEW
MINUTES, DID A
FIRE START?
REMOVE
FEED SYSTEM
AND CHECK FOR
OBSTRUCTIONS
SYSTEM IS
REPAIRED
IS THE
AUGER
FEEDING
PELLETS INTO
THE FIREPOT?
MAKE SURE
THE HOPPER
LID IS CLOSED
DID ANY RED
ALARM CODES
FLASH AFTER
5 MINUTES OF
OPERATION?
PROCEED TO
THE IGNITER
TROUBLE SHOOTING
SECTION
MAKE THE REPAIR
BY EITHER CLEANING
OR REPLACING THE
COMPONENT.
CHECK
THE VACUUM
SWITCH
CONNECTIONS
AND VACUUM
HOSE
IDENTIFY
THE CODE AND
GO TO THE
APPLICABLE
TROUBLE
SHOOTING
SECTION.
YES
NO
NO
YES
YES
NO
BAD
GOOD
BAD