Pelpro PPC90 - Trim Adjustment for Burn Control

PelPro Cast Pellet Stove • 7093-600 • 07/13/16pelprostoves.com 17
Using Your Stove
If your stove tries to start but fails on the initial burn, it will display MISSED IGNITION.
1. T u rn yo u r stove to of f , remove an d clean
the repot
2 . Conrm repot is properly positioned
3. E n su re th ere are en ou g h pellets i n th e h opper.
4 . Pri me yo u r stove per previ ou s i n stru cti on s
PWR TO RESET
MISSED IGN
Using Your Stove
Trim Adjustment
T ri m ad j u stmen t i s located i n th e men u . T h i s f eatu re w i ll
ad j u st th e ai r/f u el rati o an d b elow are ex amples of w h en to
u se i t:
WARNING!
T h i s w ood h eater n eed s peri od i c i n speci on an d repai r f or proper operati on . I t i s ag ai n st f ed eral reg u lati on s to
operate th i s w ood h eater i n a man n er i n con si sten t w i th operati n g i n stru cti on s i n th i s man u al.
• If the re is too large, lazy or producing black soot, adjust trim down one level at a time and allow
15 mi n u tes f or stab i li z ati on b ef ore mak i n g an oth er ad j u stmen t
• If your re is too small and sometimes goes out when there are pellets in the hopper, adjust
th e tri m u p on e level at a ti me an d allow 15 mi n u tes f or stab i li z ati on b ef ore mak i n g an oth er
ad j u stmen t.
Turning Your Stove Off
3
A u g er stops f eed i n g pellets.
B low ers con ti n u e to ru n u n ti l
af ter th e exh au st temperatu re
h as cooled .
1
CAUTION!
Smoke H aza rd
• Press pow er b u tton on d i splay to O F F ,
let appli an ce completely cool an d
exh au st b low er mu st b e of f . N ow yo u
can u n plu g appli an ce b ef ore servi ci n g
• Smok e spi llag e i n to room can occu r i f
appli an ce i s n ot cool b ef ore u n plu g g i n g
Press an d h old pow er b u tton
f or 3 secon d s
2
-2
TRIM