PelPro Cast Pellet Stove • 7093-600 • 07/13/16pelprostoves.com 9
Installing Your Stove
Installing Your Stove
Conrm required clearances to combustibles:
Notice: B e caref u l to protect th e b ottom of th e stove
and oor surfaces when moving the stove. Bottom
ed g es of stove are sh arp an d can scratch su rf aces.
1
1
2
3
Vertical Installations (Interior Flue)
Straight back against wall I n ch es mm
D B ack w all to pellet pi pe 3 76
E Si d e w all to stove 13 330
USA Hearth Pad Requirements I n ch es mm
A Si d es 2 5 1
B B ack 2 5 1
C F ron t 6 15 2
Horizontal Installations
Straight back against wall I n ch es mm
G B ack w all to stove 2 5 1
E Si d e w all to stove 13 330
H Clearan ce to top of stove 7 178
J Clearan ce to f ron t of stove 4 8 12 19
Corner Installation
Straight back against wall I n ch es mm
F W alls to stove 3 76
2
B *
A
C
A
Placing Your Stove
Stove must be installed on a non-combustible oor.
If needed, place oor protection (such as a hearth
pad) beneath the stove. Move stove from pallet onto
yo u r n on -comb u sti b le su rf ace. D o n ot operate th e
stove w h i le i t si ts on th e pallet.
Hearth pad minimum requirements:
Notice: Clearan ces may on ly b e red u ced b y mean s
approved b y th e reg u latory au th ori ty h avi n g j u ri sd i cti on .
Non-combustible oor protection extending beneath the ue pipe is required
w i th h ori zo n tal ven ti n g or u n d er th e top ven t ad apter w i th verti cal i n stallati on .
*Non-combustible oor protection must extend 2 inches (51mm) beneath the
ue pipe when installed horizontal venting or under the top vent adapter with
verti cal i n stallati on . CA N A D A R E Q U I R E D , U SA R E CO M M E N D E D .
3
G
E
D
J
F
F
J
H
J
Canada Hearth Pad Requirements I n ch es mm
A Si d es 8 203
B B ack 2 5 1
C F ron t 6 15 2
To Next Page
Loading...
