PelPro Cast Pellet Stove • 7093-600 • 07/13/16pelprostoves.com 5
Getting Started
Getting Started
What You’ll Need
Tools & Supplies
• H i g h temperatu re si li con e
(500°F+)
• L evel
• Ph i lli ps screw d ri ver
• Plu mb li n e
• T ape measu re
• Framing square
• R eci procati n g saw
• E lectri c d ri ll & b i ts
• Cau lki n g g u n
• Stud nder
• U ti li ty kn i f e
• Pli ers
• F lash li g h t
• H ammer
Safety Equipment
R ecommen d ed f or all i n stallati on an d mai n ten an ce steps.
Pellet Vent Pipe
Must be an approved 3” or 4” diameter Type “L” or “PL” vent. Use 4” diameter vent if ue height
is over 15’ or if installation is over 3,000 ft. above sea level.
Floor Protection
N on -comb u sti b le materi al
(such as a hearth pad) is
required underneath your
stove.
Surge Protector
Protect th e electri cal
compon en ts of yo u r stove
b y u si n g a su rg e protector.
Pellet Fuel
U se on ly w ood pellets
i n yo u r stove. F or b est
perf orman ce, u se
premi u m, low -ash pellets
(<1%) less than 1.5” in
len g th an d avoi d th e d u sty
b i ts an d pi eces of pellets
i n th e b ottom of th e b ag .
WARNING!
F i re R i sk. N O O T H E R ven t compon en ts may b e u sed . Su b sti tu te or d amag ed ven t compon en ts may
i mpai r saf e operati on .
G loves Saf ety G lasses Close-toed sh oes
To Next Page
Loading...
