Pelpro PPC90 - Blockage and Airflow Problems; Ignition and Startup Failure Resolution

PelPro Cast Pellet Stove • 7093-600 • 07/13/16pelprostoves.com 2 3
Troubleshooting
Troubleshooting
Blockage Related
Black soot on outside of house
• Conrm exhaust path is clean and clear (Zone 3)
- A d j u st ai r/f u el rati o u si n g tri m ad j u stmen t d i al
(See page 17 for trim adjustment instructions)
• E n su re termi n ati on cap h as at least 18 ” clearan ce
to red u ce th e ef f ects of soot b low -b ack on h ome
exterior (ie. siding)—if not able, refer to page 10
f or altern ate i n stallati on opti on s
1
Z o n e
1
Z o n e
2
Z o n e
2
Z o n e
3
Z o n e
3
Z o n e
Rumbling/whistling noise during operation
• Conrm exhaust path is clean and clear (Zone 3)
- Adjust air/fuel ratio using trim adjustment dial (See page 17 for trim adjustment
instructions)
Stove will not light
• Conrm repot holes are clean and clear (Zone 1)
- Ignitor is getting hot (glows orange)
• Inspect stove body (Zone 2)
- Conrm fuel is in hopper, close lid securely
- Remove right side panel to access and conrm vacuum switch is clear and
con n ected at b oth en d s
- Conrm all exhaust blower connections secure
- Conrm the feed assembly and motor are clean and clear of debris
• Conrm exhaust path is clean and clear (Zone 3)