Cyclone Universal & Cyclone Universal FX - User Manual 38
onto the Cyclone. If you are using the Cyclone Universal FX it will also allow you to store and
manage multiple images on any compatible SDHC cards that are loaded into the SDHC port.
Figure 5-11: Manage Images Utility
Upon opening a selected Cyclone, the user is provided in the top left panel with a list of the images
currently on the unit’s internal memory. If using the Cyclone Universal FX, a list of images on any
connected SDHC card will also be displayed in the bottom left panel. The panels to the right can be
used to add or delete additional images by using the Add and Remove buttons beneath each
panel.
Once the images that you wish to load appear in the panels to the right, you must press “Commit
Changes” to load the Cyclone accordingly. No changes are made to the Cyclone until the “Commit
Changes” button is pressed.
Note: Any images that are already stored on the Cyclone (or SD card, if applicable) can only be removed
by using the corresponding “Remove All Images...” button.
To Next Page
Loading...