Cyclone Universal & Cyclone Universal FX - User Manual 63
13.5 SAP Operation Errors
$0081: SAP operation is not supported, check software and firmware versions
$0082: SAP operation error, SAP image contains different target type
$0083: SAP operation cancelled
$0084: SAP running algorithm failure
13.6 SAP Blank Check Range and Module Errors
$1001: Blank check error, algorithm not supported
$1002: Blank check error, algorithm not found
$1003: Blank check operation failed
13.7 SAP Erase Range and Module Errors
$2001: Erase error, algorithm not supported
$2002: Erase error, algorithm not found
$2003: Erase error, module failed or canceled
$2004: Erase error, module failed, target is still secured
$2005: Erase error, module not performed, data is preserved
13.8 SAP Program Byte, Word, and Module Errors
$3001: Programming algorithm is not supported
$3002: Programming algorithm was not found
$3003: Program operation failed or canceled
$3004: Program operation failed, write protected
$3005: Program operation failed, nonblocking data size exceeds limit
$300A: Error during reading data block, invalid data length
$300B: Error during reading data block, invalid start address
$300C: Error during reading data block, no target power
$300D: Error during programming data block, invalid data length
$300E: Error during programming data block, invalid start address
$300F: Error during programming data block, no target power
$3010:Test Calibration Code Error
$3011: Display Feature Error
$3012: Program Feature Error
$3013: Overlay Feature Error
$3040: (MSD, Kinetis only) Error during programming, would cause device to become permanently
secured
13.9 SAP Verify Checksum Errors
$4001: VC command not supported
$4002: VC failed, invalid algorithm
$4003: VC operation failed or canceled
$4011: VV command not supported
$4012: VV failed, invalid algorithm
To Next Page
Loading...