Need help?Do you have a question about the Pentair 5600SE and is the answer not in the manual?
General| Model | 5600SE |
|---|---|
| Valve Body Material | Noryl |
| Inlet/Outlet | 1" NPT |
| Brine Connection | 3/8" Quick Connect |
| Drain Line Connection | 1/2" Push Fit |
| Electrical | 120V/60Hz or 220V/50Hz (depending on model) |
| Operating Pressure | 20-125 psi |
| Type | Water Softener |
Checklist for residential installation requirements and considerations.
Step-by-step guide for installing the control valve and initial start-up.
Procedures for setting the time, programming the control, and initiating cycles.
Instructions for manually cycling the valve and completing the final setup steps.
Explains operation for timeclock, flow meter, immediate, and delayed regeneration, and display functions.
Details control behavior during regeneration cycles and power outages.
Diagram showing water flow and component positions during normal service operation.
Diagram illustrating water flow during the Backwash regeneration step.
Diagram showing water flow during the Brine/Slow Rinse regeneration step.
Diagram illustrating water flow during the Rapid Rinse regeneration step.
Diagram showing water flow during the Brine Tank Fill regeneration step.
Detailed list of parts for the control valve assembly, including part numbers and descriptions.
Detailed list of parts for the valve powerhead assembly, including part numbers and descriptions.
List of parts for the 3" Turbine Meter Assembly, including part numbers and descriptions.
Detailed list of parts for the plastic by-pass valve assembly, including part numbers.
Detailed list of parts for the brass by-pass valve assembly, including part numbers.
List of parts for the 2300 Safety Brine Valve, including part numbers and descriptions.
List of parts for the 2310 Safety Brine Valve, including part numbers and descriptions.
Diagram illustrating the electrical connections for the valve control unit.
Step-by-step instructions for replacing key components like brine valve, timer, and piston.
Procedures for replacing the meter module and seals/spacers.
Guide to diagnose and fix common problems like no regeneration, hard water, and pressure loss.
Addresses issues like iron in water, excessive brine tank water, salt in service line, and continuous cycling.
List of service assemblies with corresponding part numbers for ordering and replacement.
To Next Page