Printed in U.S.A.
Page 5
MODEL 5600SE Downflow
Control Start-up Procedures (Cont’d.)
Depending on current control programming, option setting displays that are not required to be set will not be viewed.
3.
Set Control Programming
1. The first option setting display that appears in the Program Mode is Treated Water Capacity. Using the Set Up
or Down Buttons, set the amount of treated water that can flow through the unit before a regeneration is
required. For Example:
3. Control porgramming is now complete. Push the Extra Cycle Button. This will exit the control from the
Programming Mode, and resume Normal Operation.
2. Push the Extra Cycle Button. The second option setting display that appears is Regeneration time. Using the
Set Up or Down Buttons, set the desired time of day when a regeneration can occur, if required. For Example:
4. Control progrmming is now complete. Push the Extra Cycle Button. This will exit the control from the
Programming Mode, and resume Normal Operation.
To Next Page
Loading...
