Installer manual Autotrol Magnum 293 - 298 Logix 742-762 - Programming
Ref. MKT-IM-012 / D - 03.02.2022 47 / 110
9. "PM" Indicates that the time displayed is between 12:00 noon and
12:00 midnight.
"PM" indicator is not used if the clock mode is set to 24-hour
(there is no AM indicator).
10. "MIN" Indicates that the value entered/displayed is in minute
increments.
11. "g/L" Indicates that the value entered/displayed is in grams/Liter.
12. "KG" Indicates that the value entered/displayed is in kilograms or
kilograins.
13. "x100" x100 multiplier for large values.
14. "Lbs/ft3" Indicates that the value entered/displayed for regenerant
amount is in pounds per cubic foot.
15. Faucet Appears when the current flow rate is displayed.
The controller may show the faucet and "0", indicating no flow.
16. Maintenance interval Displayed when the month in service exceed the value
programmed in parameter P11.
17. Digits Four digits used to display the time, program value or error
codes.
18. Number Used with #19, #20 and #21.
Displays a sequence number or value.
19. History values (H) The number displayed by #18 identifies which history value is
currently displayed.
20. Parameter (P) Displayed only in advanced programming.
The number displayed by #18 identifies which parameter is
currently displayed.
21. Cycle (C) The number displayed by #18 is the current cycle in the
regeneration sequence.
22. Hardness Hardness setting - only used with 760 and 762 controllers.
23. Capacity Shows estimated system capacity.
24. "x2" Indicates a second regeneration has been called for.
25. Recycle sign Flashes when a regeneration at the next time of regeneration
has been called for.
Also displayed (continuously) when in regeneration.
26. Salt Programming the amount of regenerant.
If the controller is on a 3-cycle filter then the backwash time is
displayed.
27. Regeneration time and
day
Programming the time of regeneration and the days of
regeneration.
28. Time and day Programming the current time and day.
To Next Page
Loading...
