How to fix ERR 1 on a Pentair AUTOTROL MAGNUM 298 Control Unit?
When the Pentair Control Unit displays ERR 1, it means the controller power has been connected, but the controller is unsure of its operating status. To fix this, reset the controller.
Why does my Pentair AUTOTROL MAGNUM 298 show ERR 2?
General| Cycle Time | Adjustable |
|---|---|
| Cycle Adjustment | Fully adjustable |
| Regeneration | Time-clock, Meter Delayed, Meter Immediate, Pressure Differential |
| Voltage | 24V AC/DC |
| Control Type | Electronic |
| Valve Type | Automatic |
| Power Supply | 120V, 240V, 24V |
| Regeneration Control | Time-clock, Meter Delayed, Meter Immediate, Pressure Differential |
| Backwash Flow Rate (per sq ft) | 4.5-7.0 GPM |
Outlines steps for requesting technical support and troubleshooting.
Defines hazard symbols (Danger, Warning, Caution) and other safety icons.
States that only qualified personnel should perform work on the unit.
Highlights safety considerations regarding electrical hazards and moving parts.
Details design specifications, ratings, flow rates, and connections for the valves.
Identifies and describes the main components of the valve assembly.
Provides guidance for system sizing and configuration.
Table of recommended backwash flow rates for different media and tank diameters.
Charts detailing injector, refill, and backwash flow control parameters.
Lists flow control disc options for various drain line flow rates.
Lists essential safety warnings to follow during installation.
Provides mandatory and cautionary information for drain line connections.
Electrical safety precautions and requirements for installation.
Provides an overview of the basic programming mode.
Table detailing parameters, ranges, and defaults for 742F/293 valve types.
Step-by-step guide for basic programming of 742/762/298 valve types.
Instructions for setting the regeneration time.
Step-by-step guide for basic programming of 742F/762F/293 valve types.
How to access and use the advanced programming mode.
Table of basic programming parameters for 3-cycle filter systems.
Table of advanced programming parameters for 3-cycle filter systems.
Step-by-step guide to reset the controller to its factory default state.
Table detailing parameters, ranges, and defaults for basic programming.
Table of advanced parameters for 5-cycle softener systems.
Procedures for initial water filling, draining, and checking for leaks.
Steps to activate the softener after initial programming.
Explains how to initiate manual regeneration, delayed or immediate.
Mandatory annual inspection points for 293 CV/IT models.
Mandatory annual inspection points for 298 CV/IT models.
Steps to perform before any cleaning or maintenance.
Step-by-step guide to replacing the motor.
Step-by-step guide to replacing the camshaft.
Guide for replacing the optical sensor and controller.
Guide for replacing valve cartridges.
Mandatory safety steps before starting cleaning or maintenance.
Troubleshooting table for Logix controller error codes and issues.
Troubleshooting table for Magnum IT and Cv valve issues.
Troubleshooting steps to isolate suspect valve cartridges.
To Next Page